Yamaha AW2816 Owner's Manual page 32

I
OMNI OUT jacks
These unbalanced phone jacks are analog outputs
for the signals selected in the PATCH screen Patch
OUT page ( P.284). The nominal output level is
0 dB.
J
PHONES jack
A set of stereo headphones can be connected to
this jack. This jack will always output the same sig-
nal as the MONITOR OUT jacks.
K
DIGITAL STEREO IN jack
This is a coaxial jack for digital input of a stereo
signal. It supports the IEC 958 consumer format.
L
DIGITAL STEREO OUT jack
This is a coaxial jack for digital output of the signal
selected in the PATCH screen Patch OUT page
( P.284). It supports the IEC 958 consumer for-
mat.
M
SCSI connector
This is a D-sub half-pitch 50 pin SCSI connector
compatible with the SCSI-2 specification. External
SCSI-2 devices such as CD-RW drives or MOD
drives can be connected here.
• To connect an external device, use only a high
impedance SCSI cable with impedance of 100 ohms
(±10 ohms) and a length of 1 meter or less.
• External devices connected to the SCSI connector are
used mainly to back up song data. It is not possible to
record a song using an external SCSI device instead
of the internal hard disk.
N
TO HOST connector
This is an 8-pin mini-DIN connector that can be
connected directly to the serial port of a PC or
Macintosh for use with MIDI application pro-
grams.
O
FOOT SW jack
An optional foot switch (Yamaha FC5) can be con-
nected to this jack. You can use the foot switch to
perform transport operations such as playback/
stop, and to control manual punch-in/out.
Foot switches other than the Yamaha FC5 (or equiva-
lent) may not operate correctly.
P
MIDI IN connector
Q
MIDI OUT/THRU connector
R
MTC OUT connector
These connectors can be connected to external
MIDI devices to exchange MIDI messages.
The MIDI IN connector is for reception only.
The MIDI OUT/THRU connector can be switched
internally to function either as a MIDI OUT con-
nector (to transmit the AW2816's own MIDI mes-
sages) or as a MIDI THRU connector (to re-
transmit received messages without change).
The MTC OUT connector is dedicated to transmit-
ting MTC (MIDI Time Code).
S
POWER switch
This switch turns the power on/off.
To turn the power on/off, you must use the proce-
dures described in "Turning the power on" and
"Turning the power off," pages 11–12.
T
AC INLET connector
The included power cable is inserted into this con-
nector to supply power. Use only the included
cable.
U
Grounding terminal
This terminal is used when grounding the chassis
of the AW2816. To prevent electrical shock, you
must make this connection before plugging the
power cable into the AC outlet. This connection
will also help prevent hum and other noise.
Operation section
1
23