Yamaha AW2816 Owner's Manual page 280

MIDI screen
• List of parameters that can be assigned
Parameter 1 Parameter 2 Parameter 3
NO ASSIGN
Parameter 1 Parameter 2 Parameter 3
CHANNEL
MASTER
FADER
AUX 1 SEND
|
AUX 6 SEND
Parameter 1 Parameter 2 Parameter 3
ON
CHANNEL
MASTER
Parameter 1 Parameter 2 Parameter 3
PHASE
NOM/REV
Parameter 1 Parameter 2 Parameter 3
AUX 1 SEND
|
AUX 6 SEND
PRE/POST
Parameter 1 Parameter 2 Parameter 3
ON/OFF
TIME HIGH
DELAY
TIME LOW
• Parameters marked as (1) or (2) in this table use the
combination of two control changes to control one
parameter. For example if you want to control the
HOLD parameter of the dynamics processor, you
must specify different control change numbers for
"REL/HLD H" and REL/HLD L."
278
No parameter assigned
Control the fader of the specified channel
INPUT 1–8 Input channel 1–8
MONI 1–16 Monitor channel 1–16
RETURN 1/2 Effect return 1/2
Control the stereo output channel fader or the master level of AUX bus
1–6/bus 1–8
ST OUT Stereo output channel
AUX 1–6 AUX bus 1–6
BUS 1–8 Bus 1–8
Control the send level sent from the channel to an AUX bus 1–6. Parame-
ter 2 specifies the AUX bus, and parameter 3 specifies the desired channel.
INPUT 1–8 Input channel 1–8
MONI 1–16 Monitor channel 1–16
RETURN 1/2 Return channel 1/2
Control the on/off status of the channel [ON] key. Use parameters 2 and
3 to specify the desired channel.
INPUT 1–8 Input channel 1–8
MONI 1–16 Monitor channel 1–16
RETURN 1/2 Return channel 1/2
ST OUT Stereo output channel
Switch the phase (normal/reverse) of the specified channel.
INPUT 1–8 Input channel 1–8
MONI 1–16 Monitor channel 1–16
RETURN 1/2 Effect return 1/2
Switch the pre-fader/post-fader settings of the signal that is sent from
each channel to AUX buses 1–6. Use parameter 2 to specify the bus, and
parameter 3 to select the desired channel.
INPUT 1–8 Input channel 1–8
MONI 1–16 Monitor channel 1–16
RETURN 1/2 Effect return 1/2
Control the delay of each channel. Use parameter 2 to select the param-
eter to be controlled, and parameter 3 to select the desired channel.
Delay on/off
Delay time ... (1)
Delay time ... (2)
INPUT 1–8 Input channel 1–8
MONI 1–16 Monitor channel 1–16
RETURN 1/2 Effect return 1/2
Reference section
Content
Content
Content
Content
Content
Content
• When using control changes to control parameters, it
is not possible to switch the HIGH band EQ and
LOW band EQ parameters to shelving or low-pass/
high-pass filter.