Yamaha AW2816 Owner's Manual page 217

6
Move the cursor to the TRANSMIT button,
and press the [ENTER] key.
Bulk dump will begin. While bulk dump is being
executed, a popup window will show which data
is currently being transmitted.
Tip!
When the popup window is displayed, you can abort
the bulk dump by pressing the [ENTER] key.
• The value of the INTERVAL field specifies the length
of the time interval that will be left between each
block of bulk data transmitted from the AW2816. If
an error occurs during the bulk dump, try increasing
the INTERVAL value.
• The time required to transmit or receive a bulk
dump will depend on the category that is selected
and the data that is recorded. Particularly in the
case of automix, be aware that it may take longer,
depending on what has been recorded.
7
To receive bulk data transmitted from an
external device, press the [MIDI] key
key.
The MIDI screen/MIDI Setup 1 page will appear.
8
Move the cursor to the RX button in the
BULK area, and press the [ENTER] key to
turn the button ON.
In this state, bulk data can be received.
9
With the transport of the AW2816
stopped, transmit bulk data from the MIDI
sequencer.
When the AW2816 has received all of the bulk
data, the corresponding settings and/or libraries
will be updated.
[F1]
Operation section
13
213