Yamaha AW2816 Owner's Manual page 355

Monitor the input/output levels of tracks 1–16 (2)
Function
As in the Meter 1 page, you can moni-
tor the input/output levels of tracks 1–
16 and the output level of the stereo
output channel. In this page you can
also select the counter display units
(time/time code/measures), and switch
between absolute time display (ABS) or
relative time display (REL).
Key operations
• [METER] key [F2] (Meter 2)
• Repeatedly press the [METER] key
until the desired screen appears.
Screen functions
A
Counter select
Use the following three buttons to select the
counter display units.
• SEC button
The counter will be displayed in time units (hours/
minutes/seconds/milliseconds).
• T.C button
The counter will be displayed in timecode units
(hours/minutes/seconds/frames/sub-frames).
• MES button
The counter will be displayed in measure units
(measures/beats/ticks).
Tip!
• These buttons are independent of the SECOND/
TIME/MEASURE buttons in the DISPLAY area of the
SONG screen/Setting page. You can select a display
method that is different than the counter displayed at
the top of the screen.
• When you switch the counter to Measure display, the
ABS/REL buttons ( 2 ) will be grayed. Even when the
ABS/REL buttons are grayed you will still be able to
switch them, but the measure display will not be
affected. However, since the start point and end
point displayed in the TRACK screen/Mark Adj. page
are always displayed in time code units, they will be
affected by the setting of the ABS/REL buttons.
Meter 2 page
1 2
5
6
7
8
9
B
ABS/REL buttons
When time or time code are selected as the
counter display units, these buttons let you select
either absolute time or relative time. Absolute time
display is selected when the ABS button is on, and
relative time display is selected when the REL but-
ton is on.
Tip!
If you want to set a desired location of the song to be
"relative zero," locate to the desired location, and then
hold down the [SET] key and press the [RTZ] key. The
REL button will automatically be turned on, and the
counter will switch to relative time display.
C
Counter
This counter indicates the current location in the
song. This is the same function as the counter dis-
played in the top line of the screen.
D
REMAIN (Remaining time)
This indicates the amount of time remaining for
recording (hours: minutes). This time will change
according to the number of tracks that are in
record-ready mode.
Reference section
3 4
J K
353