Yamaha AW2816 Owner's Manual page 345

View fader movements as a bar graph
Function
Fader movements recorded in the auto-
mix are displayed as a bar graph. This is
convenient when you want to re-record
fader operations while you watch previ-
ously-recorded fader movements.
Key operation
• [AUTOMIX] key [F3] (Fader Edit)
key
• Repeatedly press the [AUTOMIX] key
until the screen shown at the right
appears.
Screen functions
A
Bar graph
This area shows the fader position of each channel
as a bar graph. (Use the keys of the MIXING
LAYER section to select the channels that are dis-
played.) For the fader being edited, both the previ-
ously-recorded position and the edited position
are displayed, as shown in the following diagram.
At this time, the arrow displayed beside the bar
graph indicates the direction in which you can
move the fader to return it to the previous position.
If you lower the fader If you raise the fader
from the previously- from the previously-
recorded position recorded position
Previously-recorded
fader position
New fader position
B
FADER EDIT OUT
The END button and RET button in this area have
the same function as the END/RET buttons in the
Main page. Please refer to the explanation on
page 338. If the RET button is on, the knob located
at the right sets the time over which the faders will
return to their original values after fader editing is
ended.
Fader Edit page
1
2
4
New fader position
Previously-recorded
fader position
Reference section
C
FADER EDIT MODE
D
AUTOMIX TRANSPORT
These are the same functions as in the Main page.
Refer to the explanation on page 338 to 340.
Additional functions in the Fader
Edit page
In the Fader Edit page you can press the [SHIFT] key
to assign the following functions to the [F1]–[F5] keys.
• [F1] (ABORT) key
• [F2] (STOP) key
• [F3] (PLAY) key
• [F4] (REC) key
• [F5] (AUTOREC) key
These are identical to the additional functions of the
Main page.
3
343