Mitsubishi Electric MELSECQ Series User Manual page 116

6 UTILITY PACKAGE (GX Configurator-PT)
6 - 11
Downloaded from ManualsNet.com
(3) Menu bar
(a) File menu
Intelligent function module parameters of the project opened by GX
Developer are handled.
[Open
parameters]
[Close
parameters]
[Save
parameters]
[Delete
parameters]
[Exit]
(b) Online menu
[Monitor/Test]
[Read from PLC] : Reads the intelligent module parameters from the CPU
[Write to PLC]
POINT
(1) Saving intelligent function module parameters in a file
Since intelligent function module parameters cannot be saved in a file by the
project saving operation of GX Developer, save them on the shown module
selection screen.
(2) Reading and writing the intelligent module parameters to and
from a PLC using GX Developer.
(a) Intelligent function module parameters can be read from and written into a
programmable controller after having been saved in a file.
(b) Set a target programmable controller CPU in GX Developer:
[Online]
(c) When the QD70 is mounted to the remote I/O station, use "Read from
PLC" and "Write to PLC" of GX Developer.
(3) Checking the required utility
While the start I/O is displayed on the Intelligent function module utility setting
screen, " " may be displayed for the model name.
This means that the required utility has not been installed or the utility cannot
be started from GX Developer.
Check the required utility, selecting [Tools] - [Intelligent function utility] - [Utility
list...] in GX Developer.
search engine
: Reads a parameter file.
: Closes the parameter file. If any data are modified, a
dialog asking for file saving will appear.
: Saves the parameter file.
: Deletes the parameter file.
: Closes this screen.
: Activates the Select monitor/test module screen.
module.
: Writes the intelligent module parameters to the CPU
module.
[Transfer setup].
MELSEC-Q
6 - 11