Toro Groundsmaste 3200 Series Installation Instructions Manual page 17

9. Route the wire-harness connector labeled
L L (J01, J02) through the hood and
ICENSE IGHT
connect it to the license light
View from the bottom of the hood
1. Wire-harness
connnection—license
plate
2. Clamp locations
3. Hex-socket screw (1/4 x 1
inch)
10. Secure the wire harness to the hood using 3
hex-socket screws (1/4 x 1 inch), 3 flat washers,
3 clamps, and 3 flange nuts (1/4 inch) as shown
in Figure 38.
(Figure 38).
Figure 38
4. Flat washer
5. Clamp
6. Flange nut (1/4 inch)
11. Connect the wire harness to the plate light
(Figure 39).
12. Secure the plate light to the assembled
speed-plate mount using the 2 speed nuts
installed in
(#10 x 3/4 inch) as shown in
1. Speed nut
g304330
2. Plate light
7
Routing the Control Wire
Harness
Parts needed for this procedure:
1 Control wire harness
Procedure
Refer to the following figures and instructions for
routing the control wire harness.
17
Figure 26 and 2 button-head bolts
Figure
Figure 39
3. Button-head bolt (#10 x
3/4 inch)
39.
g304392