Toro Groundsmaste 3200 Series Installation Instructions Manual page 10

5
Installing the Rear
Components
Parts needed for this procedure:
1 Left mount
1 Right mount
1
Left short mount
1 Right short mount
4 Carriage bolt (5/16 x 3/4 inch)
4 Flange nut (5/16 inch)
4 Carriage bolt (1/4 x 5/8 inch)
8 Locknut (1/4 inch)
2 Inner mount assembly
2 Taillight
4 Pan-head screw (#10 x 1-1/4 inches)
4 Flange nut (#10)
4 Hex-head bolt (3/8 x 3 inches)
4 Locknut (3/8 inch)
1 Marker mount
2 Back mount
4 Flange-head bolt (1/4 x 3/4 inch)
1 Speed-plate mount
2 Speed nut
5 Carriage bolt (1/4 x 1/2 inch)
5 Locknut (1/4 inch)
1 Horn-mounting bracket
1 Horn
3 20 kph speed decal
3 24 kph speed decal
1 Right, long mount
1 Left light housing
1 Right light housing
Procedure
1. Remove the flange-head bolt (3/8 x 2-3/4
inches) and flange nut (3/8 inch) securing the
bumper to the rear tube frame on each side of
the bumper (Figure
1. Rear tube frame
2. Flange-head bolt (3/8 x
2-3/4 inches)
2. Secure the left mount and right mount to rear
frame tubes using 2 hex-head bolts (3/8 x 3
inches) and 2 locknuts (3/8 inch) on each side
(Figure 22).
1. Hex-head bolt (3/8 x 3
inches)
2. Left mount
10
21).
Figure 21
3. Bumper
4. Flange nut (3/8 inch)
Figure 22
3. Locknut (3/8 inch)
g303770
g304042