Chapter 4 Network Camera Settings; Initial Start-Up Settings For Network Camera - Mitsubishi Electric MELSEC iQ-R Series User Manual

4
NETWORK CAMERA SETTINGS
This section describes the network camera settings. (The actual setting windows may differ from those in the procedure.)
4.1

Initial Start-up Settings for Network Camera

Use a web browser to configure the network camera. When the network camera is started up for the first time, network
settings such as the IP address setting are required. At the second and subsequent start-up, the camera can be accessed by
entering the password.
1.
Set the IP address of the personal computer so that it is set in the same segment as the IP address of the network
camera to be connected.
When the IP address of the network camera is unknown, check it on the network by using AXIS IP Utility.
AXIS IP Utility can be downloaded from the following URL.
www.axis.com/en
2.
Enter the IP address of the network camera in a web browser.
4 NETWORK CAMERA SETTINGS
4.1 Initial Start-up Settings for Network Camera
4
17