Locating The Jacking Points; Hauling The Machine; Locating The Tie-Down Points - Toro Groundsmaster 4000 Operator's Manual

between ports M8 and P2 on the rear traction
manifold (located behind the front tire). The hose
assembly includes 1 hose (Part No. 95-8843), 2
coupler fittings (Part No. 95-0985), and 2 hydraulic
fittings (Part No. 340-77).

Locating the Jacking Points

DANGER
Mechanical or hydraulic jacks may fail to
support machine and cause a serious injury.
• Use jack stands when supporting the
machine.
• Do not use hydraulic jacks.
There are jacking points located at the front and rear
of the machine.
•
On the frame at the inside of each front drive tire
•
At the center of the rear axle

Hauling the Machine

•
Remove the key and shut off the fuel (if equipped)
before storing or transporting the machine.
•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely.
Locating the Tie-Down
Points
There are tie downs located at the front and rear sides
of the machine (Figure
Note:
Use properly-rated DOT-approved straps in 4
corners to tie down the machine.
•
2 on the front of the operator's platform
•
Rear bumper
39).
1. Rear tie-down point
42
Figure 39
2. Front tie-down points
g196910