Toro Groundsmaster 4000 Operator's Manual page 16

Traction Pedal
To stop the machine, reduce your foot pressure on
the traction pedal and allow it to return to the center
position (Figure 3).
Brake Pedals
There are 2 foot pedals that operate individual wheel
brakes for turning assistance, parking, and to aid in
better side-hill traction. A latch connects the pedals
for parking-brake operation and transport
Pedal-Locking Latch
The pedal-locking latch connects the pedals together
to engage the parking brake
Tilt-Steering Lever
Press the tilt-steering lever down to tilt the steering
wheel to the desired position, then release the lever
to lock the adjustment
Parking-Brake Latch
To engage the parking brake, connect the pedals with
the locking latch, push down on both pedals, and
push down on the parking-brake latch while you are
pushing on the brake pedals
the pedals, you will feel the latch engage the pedals.
To disengage the parking brake, press both pedals
until the parking-brake latch releases.
Hazard-Light Switch
Press the hazard-light switch forward to engage the
hazard lights and rearward to disengage the hazard
lights (Figure 4).
Turn-Signal Switch
Press the left side of the turn-signal switch to activate
the left-turn signal and the right side of the switch to
activate the right-turn signal
Note:
The center position is off.
Key Switch
The key switch (Figure
O /P , and S
N REHEAT TART
(Figure
(Figure 3).
(Figure 3).
(Figure 3). As you push
(Figure 4).
4) has 3 positions: O
.
3).
1. Lift switches
2. PTO switch
3. Key switch
4. InfoCenter
Engine-Speed Switch
The engine-speed switch
change the engine speed. Tap the switch to increase
or decrease the engine speed in 100 rpm increments.
Hold down the switch to automatically move to High
or Low idle, depending on which end of the switch
you press.
PTO Switch
The PTO switch has 2 positions: O
I ( ). Pull the PTO button out to engage the
N STOP
mower-deck blades. Push the button in to disengage
the mower-deck blades
High-Low Speed Control
The switch
increase for transporting the machine. To switch
between the High and Low speed ranges, raise the
decks, disengage the PTO and the cruise control,
put the traction pedal into the N
move the machine at a slow speed.
Note:
The cutting decks do not operate and/or
cannot be lowered from the transport position when
the switch is in the high range.
Lift Switches
,
FF
The lift switches raise and lower the mower decks
(Figure 4). Press the switches forward to lower the
mower decks and rearward to raise the mower decks.
When starting the machine, with the mower decks in
the down position, press the lift switch down to allow
the mower decks to float and mow.
16
Figure 4
5. High-Low speed control
6. Engine-speed switch
7. Light switch (optional)
(Figure 4) has 2 modes to
(Figure 4).
(Figure 4) allows the speed range to
EUTRAL
g028453
( ) and
UT START
position, and