Locating The Jacking Points; Hauling The Machine; Locating The Tie-Down Points - Toro Groundsmaster 4000 Operator's Manual

Figure 60
1. Bypass valve (2)
2. Rotate each valve 3 turns counter-clockwise to
open and allow oil to bypass internally.
Note:
Do not open more than 3 turns. Because
fluid is bypassed, the machine can be slowly
moved without damaging the transmission.
3. Close the bypass valves before starting the
engine.
4. Torque to 70 N∙m (52 ft-lb) to close the valve.
Important:
To push or tow the machine in reverse,
you must bypass the check valve in the 4-wheel
drive manifold. To bypass the check valve,
connect a hose assembly to the reverse traction
pressure test port, located on the hydrostat, and
on the port located between ports M8 and P2 on
the rear traction manifold, which is located behind
the front tire. The hose assembly includes 1 hose
(Part No. 95-8843), 2 coupler fittings (Part No.
95-0985), and 2 hydraulic fittings (Part No. 340-77).

Locating the Jacking Points

There are jacking points located at the front and rear
of the machine.
DANGER
Mechanical or hydraulic jacks may fail to
support machine and cause a serious injury.
• Use jack stands when supporting machine.
• Do not use hydraulic jacks.
•
On the frame at the inside of each front drive tire
•
At the center of the rear axle

Hauling the Machine

•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
Locating the Tie-Down
Points
g020454
There are tie downs located at the front and rear sides
of the machine
Note:
Use properly-rated DOT-approved straps in 4
corners to tie down the machine.
•
2 on the front of the operator's platform
•
Rear bumper
1. Rear tie-down point
50
(Figure 61).
Figure 61
2. Front tie-down points
g196910