Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 4000 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours—Lubricate all of the
bearings and bushings.
Every 500 hours/Yearly (whichever comes first)
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease. Also,
lubricate the machine immediately after every
washing.
The grease-fitting locations and quantities are:
Traction Unit
•
2 front and rear-axle-pivot bushings
•
2 steering-cylinder-ball joints
•
2 tie-rod-ball joints
•
2 king-pin bushings
The top fitting on the king pin should only be
lubricated annually (2 pumps).
Figure 41
(Figure
(Figure 42)
(Figure 42)
(Figure 42).
41)
Front Mower Deck
•
2 caster-fork-shaft bushings
•
3 spindle-shaft bearings—located under the pulley
(Figure 44)
•
2 idler-arm-pivot bushings
g004687
47
Figure 42
(Figure 43)
(Figure 44)
Figure 43
g011499
g011557