Toro Groundsmaster 4000 Operator's Manual page 17

Note:
The decks do not lower while in the high-speed
range and they do not raise or lower if you are out of
the seat while the engine is running. Also, the decks
lower with the key in the O
the seat.
Cruise-Control Switch
The cruise-control switch locks in the pedal position
to maintain the desired ground speed
Pressing the rear of the switch turns off the cruise
control, the middle position of the switch enables the
cruise-control function, and the front of the switch sets
the desired ground speed.
Note:
Pressing either brake pedal or moving the
traction pedal into the reverse position, for 1 second,
also disengages the pedal position.
1. Power-point switch
Power-Point Port
Use the power-point port to power optional electrical
accessories (Figure 5).
Seat Adjustments
Seat-Adjustment Lever
Move the seat-adjustment lever on the side of the
seat outward, slide the seat to the desired position,
and release the lever to lock the seat into position
(Figure 6).
position and you are in
N
(Figure
Figure 5
2. Cruise-control switch
5).
1. Weight gauge
2. Weight-adjustment lever
3. Seat-adjustment lever
Armrest-Adjustment Knob
Rotate the knob to adjust the armrest angle.
g028454 Note:
The adjustment knob is located under the
armrest.
Seat-Back-Adjustment Lever
Move the lever to adjust the seat-back angle
6).
Weight Gauge
The weight gauge indicates when the seat is adjusted
to the weight of the operator
height by positioning the suspension within the range
of the green region.
Weight-Adjustment Lever
Use this lever to adjust to the proper weight of the
operator (Figure
the air pressure and push down to decrease the air
pressure. The proper adjustment is correct when the
weight gauge is in the green region.
17
Figure 6
4. Seat-back adjustment
lever
5. Armrest-adjustment knob
(not shown; located under
arm rest)
(Figure 6). Adjust the
6). Pull up the lever to increase
g205649
(Figure