Lubrication; Greasing The Bearings, Bushings, And Pivots - Toro LT-F3000 Operator's Manual

Lubrication

Greasing the Bearings, Bushings, and Pivots

Service Interval: Before each use or daily—Lubricate the grease-daily fittings.
Every 50 hours—Lubricate the grease every 50-hour fittings.
Important:
Lubricate the bearings, bushings, and pivot points immediately after every washing,
regardless of the service interval listed.
Grease specification: No. 2 lithium grease.
•
Use 1 pump of grease on the height-of-cut adjusters and 3 pumps of grease on all other grease fittings
•
Refer to Figure 50
•
Replace any damaged grease fittings.
1. – Grease every 50 hours
for the grease fitting locations.
Figure 50
2. – Grease daily
42
g034909