Toro LT-F3000 Operator's Manual page 16

InfoCenter Icon Descriptions (cont'd.)
Right
Left
Bulb
Output of TEC controller or control
wire in harness
Switch
Operator must release switch
Operator should change to indicated
state
Symbols are often combined to form sentences. Some
examples are shown below.
Operator should put machine in
neutral
Engine start is denied
Engine shutdown
Engine coolant is too hot
DPF ash accumulation notification.
Refer to Servicing the Diesel
Particulate Filter (DPF) in the
maintenance section for details
Reset-standby regeneration request
Parked or recovery regeneration
request
A parked or recovery regeneration is
processing.
High exhaust temperature
NOx control diagnosis malfunction;
drive the machine back to the shop
and contact your authorized Toro
distributor (software version U and
later).
The power take-off is disabled.
InfoCenter Icon Descriptions (cont'd.)
Accessible only by entering PIN
Using the Menus
To access the InfoCenter menu system, press the
menu access button while at the main screen. This
displays the main menu. Refer to the following tables
for a synopsis of the options available from the menus:
Main Menu
Menu Item
Faults
Diagnostics
Service
Settings
About
Service
Menu Item
Hours
Counts
DPF Regeneration
16
Sit down or engage the parking
brake.
Indicates that limited lift reverse is
active.
Description
Contains a list of the recent
machine faults. Refer to
the Service Manual or your
authorized Toro distributor for
more information on the Faults
menu and the information
contained there.
Lists various states that the
machine currently has; you
can use this to troubleshoot
certain issues as it quickly tells
you which machine controls
are on and which are off.
Contains information on the
machine such as hours of use,
counters, and other similar
numbers.
Allows you to customize and
modify configuration variables
on the InfoCenter display.
Lists the model number, serial
number, and software version
of your machine.
Description
Lists the total number of hours
that the machine, engine, and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due
Lists numerous counts the
machine experienced
The diesel particulate filter
regeneration option and DPF
submenus