Toro LT-F3000 Operator's Manual page 37

Maintenance Service
Interval
Every 50 hours
Every 250 hours
Every 500 hours
Every 1,000 hours
Every 1,500 hours
Every 3,000 hours
Yearly
Every 2 years
Maintenance Procedure
• Lubricate the grease every 50-hour fittings.
• Service the battery.
• Check the blade bolts.
• Inspect the blades for damage and excessive wear.
• Make sure that each blade bolt is torqued to 45 N∙m (33.2 ft-lb).
• Check the cutting unit pivot.
• Check for excessive play in the rotor bearings.
• Check the rear-roller adjustment.
• Check the rear-roller scraper wire tension.
• Torque the wheel lug nuts.
• Check the transmission-control cable.
• Check the alternator-belt tension.
• Inspect the cooling-system hoses.
• Replace the primary air filter.
• Change the engine oil and filter.
• Replace the fuel filter.
• Replace the engine fuel filter.
• Check the fuel lines and connections for deterioration, damage, or loose connections
• Check the electrical system.
• If you are not using the recommended hydraulic fluid or have ever filled the reservoir
with an alternative fluid, replace the hydraulic filters.
• If you are not using the recommended hydraulic fluid or have ever filled the reservoir
with an alternative fluid, change the hydraulic fluid.
• Adjust the engine valves.
• Check the rear wheel toe-in.
• If you are using the recommended hydraulic fluid, replace the hydraulic filters.
• If you are using the recommended hydraulic fluid, change the hydraulic fluid.
• Inspect the crankcase breather system.
• Disassemble, clean, and assemble the soot filter of the DPF.
• Inspect the ECU and related sensors and actuators.
• Inspect the turbo charger.
• Inspect, clean, and test the exhaust gas recirculation (EGR) valve.
• Inspect and test the intake throttle valve.
• Inspect and clean the injectors.
• Replace the blades.
• Flush and replace the coolant.
• Replace all moving hoses.
• Replace the transmission cable.
37