Checking The Rear Wheel Toe-In; Cooling System Maintenance; Cooling System Safety; Removing Debris From The Cooling System - Toro LT-F3000 Operator's Manual

Checking the Rear Wheel
Toe-In
Service Interval: Every 1,000 hours—Check the rear
wheel toe-in.
1. Rotate the steering wheel to position the rear
wheels straight ahead.
2. Loosen the jam nut on each end of the tie rod
(Figure 63).
Note:
The end of the tie rod with the external
groove is a left-hand thread.
Figure 63
1. Jam nut
2. Tie rod
3. To pivot the wheels, rotate the tie rod to by
turning it at the wrench flats
4. Measure the distance between the front of the
rear wheels and between the rear of the rear
wheels at axle height.
Note:
When the wheel alignment is correct,
you should measure 6 mm (1/4 inch) or less
between the front of the wheels and between
the rear of the wheels.
5. Repeat steps 3 and
between the front and rear is 6 mm (1/4 inch)
or less.
6. Tighten the jam nut on each end of the tie rod
(Figure 63).
3. Wrench flat
(Figure 63).
4 until the difference
Cooling System
Maintenance

Cooling System Safety

•
Swallowing engine coolant can cause poisoning;
keep out of reach from children and pets.
•
Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
Removing Debris from the
Cooling System
Service Interval: Before each use or daily (More
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, engage the
parking brake, and remove the key.
g004136
2. Remove the ball pin from the screen latch
(Figure 64)
1. Ball pin
2. Screen latch
3. Unlatch the engine screen, open it, and lift it
from the machine
51
frequently in dirty operating
conditions).
Figure 64
3. Back of the machine
(Figure 65).
g328488