Toro LT-F3000 Operator's Manual page 17

Service (cont'd.)
Menu Item
Backlap
Inhibit Regen
Parked Regen
Last Regen
Recover Regen
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
Protect Settings
Limited Lift Reverse
Slope Sensor Installed
Turnaround
Accessible only by entering PIN
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Accessible only by entering PIN
Description
Use to turn backlap on or off
Use to control reset
regeneration
Use to initiate a parked
regeneration
Lists the number hours since
the last reset, parked, or
recovery regeneration
Use to initiate a recovery
regeneration
Description
Controls the units used on the
InfoCenter (English or Metric)
Controls the language used
on the InfoCenter*
Controls the brightness of the
LCD display
Controls the contrast of the
LCD display
Allows an authorized person
with the PIN code to access
protected menus
Allows the ability to change
the settings in the protected
settings
Turns on or off limited lift
reverse
Indicates a slope sensor is
detected in the machine.
Turns on or off turnaround for
cutting units
Description
Lists the model number of the
machine
Lists the serial number of the
machine
Lists the software revision of
the master controller
Lists the software revision of
the InfoCenter
Lists the machine
communication bus status
Diagnostics
Menu Item
Engine Run
Decks Raise
Decks Lower
PTO
Traction
Protected Menus
There are operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter.
To lock these settings, use the Protected Menu.
Note:
At the time of delivery, the initial password code
is programmed by your authorized Toro distributor.
Accessing Protected Menus
Note:
The factory default PIN code for your machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
2. In the S
ETTINGS
scroll down to the P
the right button
17
Description
Refer to the Service Manual
or your authorized Toro
distributor for more information
on the Engine Run menu and
the information contained
there.
M , use the center button to
ENU
M and press the
ETTINGS ENU
17).
Figure 17
M , use the center button to
ENU
M and press
ROTECTED ENU
(Figure 18A).
g028523