Toro LT-F3000 Operator's Manual page 15

Using the InfoCenter LCD Display
The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics, and other information about the machine
(Figure 16). There is a splash screen and main
information screen of the InfoCenter. You can switch
between the splash screen and main information
screen at any time by pressing any of the InfoCenter
buttons and then selecting the appropriate directional
arrow.
Figure 16
1. Indicator light
2. Right button
•
Left Button, Menu Access/Back Button—press this
button to access the InfoCenter menus. You can
use it to exit any menu that you are currently using.
•
Middle Button—use this button to scroll down
menus.
•
Right Button—use this button to open a menu
where a right arrow indicates additional content.
Note:
The purpose of each button may change
depending on what is required at the time. Each
button is labeled with an icon displaying its current
function.
g020650
3. Middle button
4. Left button
InfoCenter Icon Descriptions
SERVICE DUE
15
Indicates when scheduled service
should be performed
Hours remaining until service
Reset the service hours.
The status of the engine speed
(rpm)—InfoCenter display in
languages other than English
The status of the engine speed
(rpm)—InfoCenter display in English
Info icon
Stationary regeneration is required.
The air-intake heater is active.
The operator must sit in the seat.
The parking brake is engaged.
Neutral
Coolant temperature (°C or °F)
Temperature (hot)
Not allowed
Start the engine.
The PTO is on.
Shut off the engine.
Engine
Key switch
Cutting units are lowering
Cutting units are raising
CAN bus
InfoCenter
Bad or failed
Center