Connection Cable; Mechanical Attachment - Bosch Rexroth IndraDyn A Series Project Planning Manual

Rexroth IndraDyn A

Connection cable

Thermal stability

13.7 Mechanical Attachment

Preparation
Mounting
DOK-MOTOR*-MAD/MAF****-PR03-EN-P
Bosch Rexroth scope of delivery and must be provided by the
user.
Certification of the motors according to the ignition protection class
• EEx d (encoder housing)
• EEx p (motor housing)
according to EN 50018:2001 and EN 50016:2003 was made using a
control device of type 07-3711-2213/1002, manufactured by
⇒ BARTEC GmbH
Max-Eyth-Str. 16
97980 Bad Mergentheim, Germany Email info@bartec.de
PO Box 1166
97961 Bad Mergentheim, Germany
Observe the notes
commissioning the control device when designing the drive system.
Use cables with a thermal stability of at least 80°C (176°F) to operate the
motor in hazardous areas.
Bosch Rexroth provides suitable ready-made connection cables for the
motors. They are checked on conformity with the ATEX guidelines and
relevant DIN and EN standards. When selecting cables, use the following
documentation: DOK-CONNEC-CABLE-*STAND-AUxx-EN-P
R911282688).
Before installing the motor, check whether the required information is
present on the type label of the motor, such as the
• device group and device category,
• explosion subgroup,
• maximum permitted surface temperature,
correspond to the local permitted conditions for use in hazardous areas.
Check the components for visible damage. Defective components may
not be mounted.
Before installation, ensure that the environmental conditions at the
location of use, such as the ambient temperature, the humidity, the
vibration, and shock stresses do not exceed the details in the project
planning manual of the motor.
IndraDyn A motors are manufactured either for flange assembly (design
05) or for foot assembly (design 35). You can find details regarding the
fastening holes in the motor dimension sheet in the project planning
manual. For fastening, the following general assignment applies:
Motors for Hazardous Areas
Tel. +49 (0)7931 597-0
Fax +49 (0)7931 597-119
of the manufacturer
13-9
when selecting and
(MNR