Connection Designations At The Drive Control Device; Double Cabling - Bosch Rexroth IndraDyn A Series Project Planning Manual

Rexroth IndraDyn A
8.5

Connection Designations at the Drive Control Device

REXROTH
drive control device
IndraDrive
DIAX04
ECODRIVE
8.6

Double Cabling

DOK-MOTOR*-MAD/MAF****-PR03-EN-P
PTC-Resistor
replacement
PTC-Resistor
Fig. 8-9: Example of a terminal box lid
The following overview shows the connection and clamp designations for
power connection, brake connection and the motor temperature
monitoring at the respective Rexroth drive controller.
Power
(terminal box X5)
A1, A2, A3
A1, A2, A3
A1, A2, A3
Fig. 8-10: Clamp designations on drive control device
A motor connection with two power cables is required if a corresponding
single cable cannot be used due to the large bending radius or due to its
dimensions.
Note: Double cabling can only be effected with power connection by
means of terminal box.
Connection Techniques
M
Brake
Clamp designation
Temperature sensor
(terminal box X6)
MotTemp+
MotTemp-
TM+
TM-
TM+
TM-
8-7
MAx_Power_Box2.EPS
Holding brake
+24VBr
0VBr
Br+
Br-
Br+
Br-