Table of Contents
Advertisement
Installing DIGI KEYER consists of several steps:
1) prepare DIGI KEYER to work with your radio
2) install microHAM USB Device Router (the control and interface software)
configure the Windows USB Audio Device
3) configure Router
1.
Remove the top cover from the DIGI KEYER and set the CAT jumpers as shown in the following chart.
CAT interface jumpers must be configured to select the proper level for each radio type.
RS-232 levels:
All transceivers with RS-232 CAT ports.
IF-232 levels:
Kenwood: TS-140, 440, 450, 680, 690, 711, 790,
811, 850, 940, 950
FIF-232 levels:
Yaesu: FT-100, 736, 747, 757GXII, 767, 817, 840,
857, 890, 897, 900, 980, 990, 1000, 1000D
CI-V levels:
Icom: all radios except 7700 & 7800 with RS-232
TenTec: all radios with 3.5 mm connector
NOTE: the CAT interface is not configured at the factory.
2. Plug the DB15M on the radio cable set into the DB15 connector on the rear panel of the DIGI
KEYER and plug ALL connectors from the cable set to the appropriate jacks at the rear panel of
your transceiver. Each connector on the radio interface cable is marked same as the matching jack
on your transceiver.
3. If the radio cable ends with leads for external power, connect these leads to a 12-16V DC power
supply.
Be sure to observe the proper polarity.
4. Locate but do not connect the USB cable from DigiKeyer to your computer.
NOTE: If you will be installing on a Windows computer, skip to "MICROSOFT WINDOWS
(Windows 2000, XP, Vista, & Windows 7) INSTALLATION."
microHAM © 2016 All rights reserved
4 - INSTALLATION
Preparing DigiKeyer for Use
6
The
RS232
IF232
FIF232
CI-V
Advertisement
Table of Contents
