Setting Audio Levels - microHAM DigiKeyer Manual

There are three pots on DIGI KEYER for adjusting audio levels.
The TX Pot adjusts the level of audio to the transmitter. The RX MAIN Pot provides adjustment of the
audio from the radio (main receiver) to the sound card (computer) left channel. The RX SUB Pot provides
adjustment of the audio from the radio (sub-receiver) or a second receiver to the sound card (computer)
right channel.
IMPORTANT: Many transceivers, including all Yaesu transceivers, MUST be switched to a
special digital mode (DIG, PKT, DATA, USB-D/LSB-D etc.) to enable the rear panel line input!
1. Set the TX control on Digikeyer to the 12:00 position.
2. On Router's Keying tab, click the "Sound Card" button.
3. On the "Audio Devices" window, select "Speakers (USB Audio CODEC)" in the Mixer and WaveOut
boxes.
NOTE: You may need the WaveOut and WaveIn indexes of the sound card to configure some
programs. Make note of them or remember where you can find the "Sound Card ID" numbers.
microHAM © 2016 All rights reserved

6 - SETTING AUDIO LEVELS

25