microHAM DigiKeyer Manual page 18

WARNING: DO NOT select "Disable Router queries" unless you have a specific reason to do so. Router
only polls for information that is not requested by the logger and does not interfere with logger polling.
Disabling Router queries may result in incorrect frequency and/or mode decoding and can have a serious
impact on overall operation.
PW1 on radio bus – When this box checked, Router periodically generates an Icom "Transceive"
broadcast to keep the PW1 synchronized.
NOTE: Check this box if you have an IC-PW1 or other Icom compatible accessory physically
connected (in parallel with the transceiver). Do not check this box if the only connection is to
the transceiver and the PW1 or other other accessory is connected to the accessory CI-V PA
port (described later).
Tracking:
Tracking: This function allows an external receiver to track the transceiver attached to
DigiKeyer.
NOTE: For specific information, please refer to Appendix C..
The bottom two-thirds of the Radio window is a serial communication monitor. The monitor uses colors and tags
to indicate which device is responsible for the data. Black queries (H1-TX or H2-TX) and grey radio responses
(H1-RX or H2-TX) are from the "host" application (e.g., logger), H1 indicates the host application on the main
CAT port, H2 is the host application on the 2
from/to Router and not routed to the application.
Router monitors the communication when the host application performs control and polls the radio periodically
for any missing information (VFO frequencies and mode). Because some applications do not poll the radio
regularly or completely, Router must break this communication to update its internal state. In order to avoid
confusing the application when Router polls the radio, data from the application is buffered and sent to the radio
after Router receives a response to its query. If Router does not receive response to a poll within the time
allowed or does not understand the response, it displays "oldest query discarded" but forwards all data to the
virtual serial port to avoid confusing the application (logger).
Since USB transmits data in frames with a delay between frames, Router indicates frame boundaries with three
dots (...). When a packet ends with three dots it means that the data continues in the next frame.
microHAM © 2016 All rights reserved
nd
CAT port. Green packets (R-TX and R-RX) are polls/responses
18