Table of Contents
Advertisement
Once the virtual ports have been created they must be associated with a specific device channel (e.g.,
Control, CW, PTT, etc.). These assignments should correspond to settings of the application software and
must be configured first in Router then in the application (e.g., logging program, MMTTY, STREAM, etc.).
Proper configuration of the port assignments in this tab is critical for integration with loggers. Read
the following information carefully.
DigiKeyer has nine functions with indication of the state and settings applied by the host application
CAT (uses RxD and TxD)
●
nd
2
CAT (virtual "fork" for the main CAT channel)
●
FSK (uses TxD and optionally RTS/DTR for PTT)
●
nd
2
FSK (uses TxD and optionally RTS/DTR for PTT)
●
CW (uses DTR or RTS)
●
PTT (uses DTR or RTS)
●
nd
2
PTT (uses DTR or RTS)
●
Squelch (uses CTS, DCD, DSR or RING)
●
Control (uses RxD and TxD)
●
General note: Do not assign virtual ports to those functions which are not used by the application. It is
unnecessary and only consumes resources.
microHAM © 2016 All rights reserved
Ports Tab
16
Advertisement
Table of Contents
