Replacing Batteries For The Fire Alarm Control Panel (Standard) - Huawei FusionModule 1000B Maintenance Manual

FusionModule1000B Air-Cooled IT Solution
Maintenance Guide
Step 8 Use a Phillips screwdriver to tighten the screws at the upper and lower parts of the new
emergency start/abort switch.
Step 9 Switch on the active and standby power supplies to the fire alarm control panel.
Step 10 Check that the new emergency start/abort switch is working properly.
----End
Follow-up Procedure
Dispose of the removed emergency start/abort switch that is confirmed faulty.
6.4.8 Replacing Batteries for the Fire Alarm Control Panel
(Standard)
Prerequisites


Impact on the System
None
Preparations
Tools: protective gloves, step ladder, Phillips screwdriver
Materials: spare fire alarm control panel batteries
Documents: fire extinguishing device layout diagram (standard)
Skill requirement: fire engineer
Procedure
Step 1 Switch off the standby power supply to the fire alarm control panel.
Issue 02 (2017-01-10)
If the run indicator of the new emergency start/abort switch is on after power-on, the emergency
start/abort switch is working properly.
Fire alarm control panel batteries need to be replaced.
Spare fire alarm control panel batteries of the same model are available and functional.
For the diagrams, see the initial configuration parameter manual for the solution in use.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Parts Replacement
140