Huawei FusionModule2000 Product Description page 98

FusionModule2000 Smart Modular Data Center
Product Description (380 V)
Indicator
Wireless Network Pairing (SW) and IP Address Reset (Default) Buttons
Table 3-55 Wireless network pairing and IP address reset buttons
Button
Name
SW
Default
Issue 04 (2017-06-30)
Color Name
Function Operation Description
Description
Wireless In non-wireless network (802.15.4)
network RF_Z pairing mode, press and hold down
(802.15.4) the button for 1.2s to 5s to enter the
pairing wireless network pairing mode.
In wireless network (802.15.4)
pairing mode, press and hold down
the button for 1.2s to 5s to exit the
pairing mode; or the system
automatically exits the pairing mode
after 30 minutes without pressing
the button.
Press and hold down the button for
more than 6s to clear network
parameters.
WiFi pairing In non-WiFi pairing mode, press the
button button for less than 1.2s to enter the
WiFi pairing mode.
IP address reset Press and hold down the button for
3s. Then the IP address for the
ECC800 WAN_1 port will restore
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Status Description
The converter delivers no
output due to internal faults.
Off The converter is working
properly.
Indicator Status
The RF_Z indicator
is blinking at super
short intervals.
The RF_Z indicator
is blinking at long
intervals.
The RF_Z indicator
is on.



None
3 System Architecture
When the system
enters the pairing
mode, the RUN
indicator is
steady on.
After pairing
succeeds, the
RUN indicator
blinks just as
before WiFi
pairing.
If pairing does
not succeed for 3
minutes, the RUN
indicator blinks
just as before
WiFi pairing.
91