Huawei FusionModule2000 Product Description page 127

FusionModule2000 Smart Modular Data Center
Product Description (380 V)
Item
WiFi function
PoE port
Reset button
WPS button
Indicators
Table 3-86 describes the indicators on the WiFi converter.
Table 3-86 WiFi converter indicators
Indicat
or
RUN
ALM
WiFi
WPS
Issue 04 (2017-06-30)
Specifications

2.4 GHz frequency, two antennas, supporting eight STA connections,
50 m WiFi coverage (no blockage)

Supports the WPS button.
One PoE port, complying with IEEE802.3AT, 25.5 W
Press and hold down the button for more than 5s to restore the factory
settings of the WiFi converter.
Support fast WiFi access by WPS
WPS function: When WiFi is enabled, if you choose Advanced settings > WPS connection on the
WLAN of an intelligent device (such as a mobile phone and pad) and press the WPS button on the WiFi
converter at the same time, the intelligent device will quickly connect to the WiFi hotspot of the smart
module.
Col Name
or
Gree Running status
n indicator
Red Alarm indicator
Gree WiFi status
n indicator
Gree WPS mode
n indicator
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Status Description
Steady on The power supply is normal.
Off The power supply is abnormal.
Blinking at The WiFi converter has successfully
long intervals registered with the ECC800 and the
software runs properly (blinking at
0.5 Hz, on for 1s and then off for
1s).
Blinking at The WiFi converter has failed to
short intervals register with the ECC800 or the
communication is disconnected (the
indicator blinks at 4 Hz, on for
0.125s and then off for 0.125s).
Steady on A system fault alarm is generated.
Off No system alarm is generated.
Steady on The WiFi converter is powered on
but there is no data communication.
Blinking Data communication is in progress.
Off The WPS is normal.
Blinking WPS matching mode. If the
matching fails, the WPS indicator
3 System Architecture
120