Installing A Drive With Screws (Frames R0...R8) - ABB ACS560 Quick Installation And Start-Up Manual

6 EN - Quick installation and start-up guide
￭

Installing a drive with screws (frames R0...R8)

All drives of frames R0...R8 can be installed on a wall with screws. See the required
screw sizes in below mounting dimensions table. See also
free space requirements (page 122)
WARNING!
The drive module (frames R6...R8) is heavy (45 to 70 kg). Consider the following:
• Use a suitable lifting device.
• Do not lift the module manually.
• Make sure that the wall and the fixing devices can carry the weight. See data
in the table below.
1. Mark the mounting hole locations using the mounting template included in the
EN
package.
HI
Mounting template
2. Drill the mounting holes.
3. Tighten the screws into the mounting holes.
4. Position the drive onto the screws on the wall.
5. Tighten the mounting screws.
Mounting dimensions
Frames R0 R1 R2
Screws M5
(mm)
a 191
b
50 75 148
d 75
e 75
Weight 4.47 4.57 7.54
(kg)
Dimensions, weights and
R3 R4 R5
M6
473 619 581
- 612
160
-
200
14.86 23.0 28.0
R6 R7 R8
M8
531 583 658
571 623 701
213 245 263
45.0 55.0 70.0