R6...R8 1. Install the side plates (1a) of the cable box. Tighten the retaining screws (1b) with
32 EN - Quick installation and start-up guide
2. Slide the cover (2a) of the cable box on the module from below until the cover
Frames
3. Reinstall the module cover (3a). Tighten the two retaining screws (3b) with a
Action
1a
Start up and use
This section describes how to install and start-up the drive using the basic control panel.
EN
Only limited information may be available in this manual. For detailed information of all
HI
Menus and Sub menus, see the ACS-BP-S basic control panel user manual
(3AXD50000032527 [English]).
■
Before you start
Make sure that the drive is installed as described in section
a screw driver.
snaps into place.
screwdriver.
1b
3a
2a
3b
Install the drive (page
EN
ES
5).
PL
TR
ZH