Parameters Related To Cc-Link Ie Tsn - Mitsubishi Electric 800 Series Instruction Manual

NOTE
• If the FR-E800-E cannot be detected, on the menu bar select [Diagnostics (D)] > [CC Link IE TSN / CC Link IE Field
Diagnostics]. The "CC Link IE TSN / CC Link IE Field Diagnostics" window will be displayed. Broken or disconnected wires
can be detected.
XX-XX-XX-XX-XX-XX
2.5.3

Parameters related to CC-Link IE TSN

The following parameters are used for CC-Link IE TSN communication. Set the parameters as required.
Pr.
541 Frequency command sign
N100 selection
544
CC-Link extended setting
*1
N103
1426
Link speed and duplex mode
*1
selection
N641
1442
Ethernet IP filter address 1
*1
N660
1443
Ethernet IP filter address 2
*1
N661
1444
Ethernet IP filter address 3
*1
N662
1445
Ethernet IP filter address 4
*1
N663
1446
Ethernet IP filter address 2
*1
range specification
N664
1447
Ethernet IP filter address 3
*1
range specification
N665
1448
Ethernet IP filter address 4
*1
range specification
N666
804 Torque command source
D400 selection
810 Torque limit input method
H700 selection
*1 The setting is applied after an inverter reset or next power-ON.
20
2. Ethernet Communication
2.5 CC-Link IE TSN
XXX.XXX.XXX.XXX
Name Initial value
0
0
0
0
0
0
0
9999
9999
9999
0
0
Setting range
0 Signed frequency command value
1 Unsigned frequency command value
0, 1, 12, 14, 18, Use this parameter to extend the function of the remote
100, 112, 114, 118 registers for the CC-Link IE TSN.
0 to 4 Set the communication mode (full-duplex/half-duplex).
0 to 255
Set the range of connectable IP addresses for the
network devices. (When Pr.1442 to Pr.1445 = "0 (initial
value)", the function is invalid.)
0 to 255, 9999
In the torque control mode, the torque command source
0, 1, 3 to 6
can be selected.
0 to 2 The torque limit input method can be selected.
Description