Cc-Link Ie Tsn; Outline - Mitsubishi Electric 800 Series Instruction Manual

2.5

CC-Link IE TSN

2.5.1

Outline

Data can be transmitted to IT systems while performing real-time cyclic communication control.
 CC-Link IE TSN authentication classes
• Devices (nodes) and switches on the CC-Link IE TSN network are classified into different authentication classes according
to their functionality and performance. There are two authentication classes: A and B. For details of the authentication class
of each product, check the information on the web site of the CC-Link Partner Association, or refer to catalogs and manuals
of each product. Different functions and system configurations are available depending on the authentication class of the
devices to be used. For example, use authentication class B devices to construct a high-speed motion control system. For
details of system construction such as mixing devices of both class A and class B, check the manuals of the applicable
master device.
 Communication specifications
The communication specification varies depending on the specification of the master.
Item
Transmission speed
Minimum synchronization cycle
Authentication class
Communication method
Synchronization function
Maximum number of connected units
Maximum number of branches
Connection cable
Node type
Maximum cyclic size (of
one node)
NOTE
• To use the CC-Link IE TSN, do not install the FR-A8NC to the inverter. (Installing the FR-A8NC E kit disables CC-Link IE TSN.)
 Operation status LEDs
LED name
NS Communication status
MS Inverter status
LINK1 Connector for communication (PORT1) status
LINK2 Connector for communication (PORT2) status
16
2. Ethernet Communication
2.5 CC-Link IE TSN
100 Mbps (10 Mbps is not supported.)
5000.00 μs
Authentication class A
Time sharing method
Conforms to IEEE 1588v2
121 units (sum of master and slave stations)
No upper limit on the same Ethernet network
Ethernet cable (IEEE 802.3 100BASE-TX compliant cable or ANSI/TIA/EIA-568-B (Category 5)
compliant shielded 4-pair branched cable)
Slave station
RX 32 bits
RY 32 bits
RWr 32 words
RWw 32 words
Description
Description
LED status
OFF Power-OFF
Blinking green Data transmission not performed
Solid green Data transmission in progress
Blinking red Communication interrupted
Solid red Duplicate IP address detected
OFF Power-OFF / inverter reset
Green Operating properly
Red Fault detected
OFF Power-OFF/link-down
Blinking green Link-up (Data reception in progress)
Solid green Link-up
OFF Power-OFF/link-down
Blinking green Link-up (Data reception in progress)
Solid green Link-up
Remarks