Cooling System Maintenance; Cooling System Safety; Checking The Cooling System - Toro Groundsmaster 360 Operator's Manual

synchronization of the wheel alignment should
occur.
Important:
Doing this procedure on turf can
result in turf damage directly under each of
the turning tires.
Cooling System
Maintenance

Cooling System Safety

•
Swallowing engine coolant can cause poisoning;
keep out of reach from children and pets.
•
Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
•
Do not operate the machine without the covers
in place.
•
Keep your fingers, hands and clothing clear of
rotating fan and drive belt.
Checking the Cooling
System
Service Interval: Before each use or daily
The cooling system is filled with a 50/50 solution
of water and permanent ethylene glycol anti freeze.
Check the level of the coolant in the expansion tank at
the beginning of each day before starting the engine.
The capacity of the cooling system is 7.5 L (6 US qt).
1. Check the level of the coolant in the expansion
tank (Figure 82). The coolant level should be
between the marks on the side of the tank.
2. If coolant level is low, remove the expansion tank
cap and replenish the system. Do not overfill.
3. Install the expansion-tank cap.
1. Expansion tank
58
Figure 82
g014268