Attachments/Accessories; Before Operation; Before Operation Safety - Toro Groundsmaster 360 Operator's Manual

Weight of the Machine with Cutting Units
4-Wheel
Drive
Machine
with ROPS
No cutting 1,152 kg
unit (2,540 lb)
72 inch side 1,363 kg
discharge (3,004 lb)
cutting unit
72 inch base 1,341 kg
cutting unit (2,956 lb)
62 inch base 1,324 kg
cutting unit (2,918 lb)
100 inch rear 1,510 kg
discharge (3,330 lb)
cutting unit

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
2-Wheel
Machine Drive
with Cab Machine
with ROPS
1,435 kg 1,130 kg
(3,163 lb) (2,492 lb)
1,645 kg 1,341 kg
(3,627 lb) (2,956 lb)
1,623 kg 1,319 kg
(3,579 lb) (2,908 lb)
1,606 kg 1,302 kg
(3,541 lb) (2,870 lb)
1,793 kg 1,489 kg
(3,953 lb) (3,282 lb)
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.

Before Operation

Before Operation Safety

General Safety
•
Never allow children or untrained people to
operate or service the machine. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Shut off the engine, remove the key (if equipped),
and wait for all movement to stop before you leave
the operator's position, Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Know how to stop the machine and shut off the
engine quickly.
•
Check that operator-presence controls, safety
switches, and guards are attached and functioning
properly. Do not operate the machine unless they
are functioning properly.
•
Before mowing, always inspect the machine to
ensure that the blades, blade bolts, and cutting
assemblies are in good working condition.
Replace worn or damaged blades and bolts in sets
to preserve balance.
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
Fuel Safety
•
Use extreme care in handling fuel. It is flammable
and its vapors are explosive.
•
Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
•
Use only an approved fuel container.
•
Do not remove the fuel cap or fill the fuel tank
while the engine is running or hot.
•
Do not add or drain fuel in an enclosed space.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
•
If you spill fuel, do not attempt to start the engine;
avoid creating any source of ignition until the fuel
vapors have dissipated.
21