1. Roll bar
2. Pin
4
Checking the Tire Pressure
No Parts Required
Procedure
Check the tire pressure; refer to
Pressure (page
57).
Important:
Maintain pressure in all tires to
ensure a good quality-of-cut and proper machine
performance. Do not underinflate the tires.
5
Checking the Fluid Levels
No Parts Required
Procedure
1.
Check the hydraulic-fluid level before starting
the engine, refer to
System (page
62).
2.
Check the engine-oil level before starting the
engine, refer to
Checking the Engine-Oil Level
(page
52).
Figure 5
3. Hairpin cotter
Checking the Tire
Checking the Hydraulic
3.
Check the cooling system before starting the
engine; refer to
(page
58).
6
Installing the Decal (CE
Machines Only)
Parts needed for this procedure:
g014166
1
Model year decal
Procedure
Install the model year decal next to the serial number
plate on the machine
Note:
For EN ISO 5395, complete the installation of
the CE Kit. Contact your authorized Toro distributor
for the correct CE Kit.
1. Model year decal
13
Checking the Cooling System
(Figure
6).
Figure 6
g278147