Toro Groundsmaster 360 Operator's Manual page 16

InfoCenter Icon Description (cont'd.)
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
Operator must release switch
Operator should change to indicated
state
Symbols are often
combined to form
sentences. Some
examples are shown
below
Operator should put machine in
Neutral
Engine start denied
Engine shutdown
Engine coolant too hot
Sit down or engage parking brake
DPF ash accumulation
notification. Refer to
the Diesel-Oxidation Catalyst (DOC)
and the Soot Filter (page 53)
details.
Reset-standby regeneration request
Parked or recovery regeneration
request
A parked or recovery regeneration is
processing.
InfoCenter Icon Description (cont'd.)
Using the Menus
To access the InfoCenter menu system, press the
menu access button while at the main screen. This
brings you to the main menu. Refer to the following
tables for a synopsis of the options available from
the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
Servicing
for
Settings
About
Service
Menu Item
16
High exhaust temperature
NOx control diagnosis malfunction;
drive the machine back to the shop
and contact your authorized Toro
distributor (software version T and
later).
Description
The Faults menu contains
a list of the recent machine
faults. Refer to the Service
Manual or your authorized
Toro distributor for more
information on the Faults
menu and the information
contained there.
The Service menu contains
information on the machine
such as hours of use counters
and other similar numbers.
The Diagnostics menu
displays the state of each
machine switch, sensor and
control output. You can use
this to troubleshoot certain
issues as it will quickly tell you
which machine controls are on
and which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description