Starting The Engine; Shutting Off The Engine - Toro Groundsmaster 360 Operator's Manual

1. Pin
2. Hairpin
3. Raise the roll bar to the upright position
22).
4. Secure the roll bar with the 2 pins and 2 hairpins
(Figure 22).
Lowering the Roll Bar
Important:
Do not use the seat belt when the roll
bar is in the lowered position.
1. Remove the hairpins, push the roll bar forward
against the springs, and remove the 2 pins
(Figure 22).
2. Lower the roll bar to the down position
22).
3. Install the 2 pins into the pivot plates and secure
the pins with the 2 hairpins

Starting the Engine

1. If installed, raise the roll bar up and lock it into
place, sit on the seat, and fasten the seat belt.
2. Ensure that the traction pedal is in the N
position.
3. Engage the parking brake.
4. Move the power-takeoff (PTO) switch to the O
position (Figure
Figure 22
3. Roll bar (raised position)
4. Roll bar (lowered position)
(Figure 22).
23).
1. InfoCenter
2. Power-takeoff (PTO)
switch
5. Turn the key clockwise to the R
Note:
g014172
in 6 seconds.
6. After the InfoCenter glow-plug icon goes out,
turn the key to the S
engine starts, release the key.
(Figure
Important:
more than 15 seconds per minute to avoid
overheating the starter motor.
Note:
required when starting the engine for the first
time after the fuel system has been completely
drained.
Important:
the first time, or after an engine oil change or
an overhaul of the engine, the transmission,
or a wheel motor, operate the machine with
the engine-speed switch in the Slow position
in both the forward and reverse directions
(Figure
for 1 to 2 minutes. Also operate the deck
lift switch and the PTO switch to ensure
proper operation of all the parts. Then shut
the engine off and check the fluid levels
and check for oil leaks, loose parts, and any
other noticeable malfunctions.

Shutting Off the Engine

1. Park the machine on a level surface.
EUTRAL
2. Disengage the PTO, make sure that the traction
pedal is in the N
parking brake, and move the engine-speed
FF
switch to the idle position.
3. Let the engine idle for 60 seconds.
4. Turn the key to the
28
Figure 23
3. Engine-speed switch
4. Key switch
The InfoCenter glow-plug icon turns on
position. When the
TART
Use starting cycles of no
Additional starting cycles may be
When you start the engine for
position, engage the
EUTRAL
position.
OFF
g026090
position.
UN