Hauling The Machine; Locating The Tie-Down Points - Toro Groundsmaster 360 Operator's Manual

Pushing the Machine
1. Disengage the power takeoff (PTO), turn the key
to the O position, remove the key, and engage
FF
the parking brake.
2. Lift the seat.
3. Rotate each bypass valve counterclockwise
1 turn (Figure 63).
Note:
This allows hydraulic fluid to bypass the
pump, enabling the wheels to turn.
Important:
Do not rotate the bypass valves
more than 1 turn. This prevents the valves
from coming out of the body and causing
fluid to run out.
4. Disengage the parking brake before pushing
the machine.
Changing to Machine Operation
1. Rotate each bypass valve clockwise 1 turn and
hand tighten them
Note:
Do not overtighten the bypass valves.
2. Torque the valves approximately 8 N∙m (71 in-lb)
as shown in Figure
Note:
The machine does not drive unless the bypass
valves are turned in.
Figure 63
1. Bypass valves

Hauling the Machine

•
Remove the key and shut off the fuel (if equipped)
before storing or transporting the machine.
•
Use care when loading or unloading the machine
into a trailer or a truck.
(Figure 63).
63.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely.
Locating the Tie-Down
Points
There are tie downs located at the front and rear sides
of the machine
Note:
Use properly-rated DOT-approved straps in 4
corners to tie down the machine.
•
2 on the front of the operator's platform
•
Rear tire
g014270
1. Front tie-down point
44
(Figure 64).
Figure 64
2. Rear tie-down point
g014264