Table of Contents
Advertisement
To release the platform and swing it out or in, press up on the
front platform latch
(Figure
1. Front platform latch
Control Panel
1
2
3
4
5
1. Engine-stop button
2. Exit-side lockout—reset
light
3. Exit-side
lockout—drill-enabled
light
4. Receiver-battery-status
light
5. Engine-start button
Exit-Side Lockout—Reset Light
This light
(Figure
12) illuminates yellow when the exit-side
lockout function is turned off on exit-side-lockout transmitter,
indicating that you may reset the system.
11).
Figure 11
Figure 12
6. Ground-strike-reset switch
7. Exit-side-lockout—reset
switch
8. Drive/drill switch
9. Lights switch
10. Engine-speed switch
Exit-Side Lockout—Drill-enabled Light
This light
(Figure
exit-side-lockout feature has been turned off and reset and
the machine is ready to drill.
Exit-Side Lockout—Reset Switch
Press this switch
the reset light illuminates.
Transmitter-Battery—Status Light
This light
(Figure
the exit-side-lockout transmitter is too low to transmit. Stop
drilling operations and fix the problem with the transmitter
before continuing.
Engine-Start Button
Press this button
switch on the rear, control panel must be in the O
Engine-Stop Button
Press this button
6
and all drilling operations. You must pull this button out
before you can start the engine again.
7
Ground-Strike-Reset Switch
Press this switch
8
after a ground strike has occurred and been fixed; refer to
Deploying the Zap-Alert System (page
9
Drive/Drill Switch
10
Press the top of this switch
setup controls or the bottom to enable drill and pipe-loader
functions.
g0 28900
Lights Switch
Press the top of this switch
lights on or the bottom to turn them off.
Engine-Speed Switch
•
Press and hold the top of this switch to increase the
engine speed.
•
Press and hold the bottom of this switch to decrease the
engine speed.
•
Release the switch to maintain the current engine speed.
22
12) illuminates green when the
(Figure
12) to enable drilling operation when
12) illuminates red when the battery on
(Figure
12) to start the engine. The key
(Figure
12) to immediately stop the engine
(Figure
12) to reset the Zap-Alert system
46).
(Figure
12) to enable the drive and
(Figure
12) to turn the machine
position.
N
Advertisement
Table of Contents
