Table of Contents
Advertisement
Changing the Oil for the
Planetary Drive
Service Interval: After the first 250 hours—Change the
planetary oil.
Every 800 hours—Change the planetary oil (or yearly,
whichever comes first).
Note: Change the oil when it is warm, if possible.
1. Park the machine on a level surface.
2. Clean the area around the oil-level plug
3. Rotate the planetary drive until the oil-drain plug is
directly below the oil-level plug
4. Stop the engine and remove the key.
5. Place a drain pan under the oil-drain plug.
6. Remove the oil-level plug and the oil-drain plug.
7. Install the oil-drain plug.
8. Fill the chain drive planetary with oil until the oil even
with the bottom of the oil-level plug hole.
9. Install the oil-level plug.
10. Repeat steps
1
through
oil on the other side of the machine.
Checking the Oil for the
Gearbox Drive
Service Interval: After the first 100 hours—Check the
gearbox drive oil.
Every 500 hours—Check the gearbox drive oil (or
yearly, whichever comes first).
Oil specification: SAE 85W-140 API classification level GL4
Planetary-drive oil capacity: approximately 2.7 L (5.75 US
pt)
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Check the oil level on the sight-glass on the gearbox
drive
(Figure
96).
Note: The oil level should cover half of the sight-glass.
(Figure
95).
(Figure
95).
9
to change the planetary-drive
1. Sight-glass
3. Remove the breather cap and add the oil into the
gearbox drive until the oil level on the sight-glass is at
least half full
(Figure
Changing the Oil for the
Gearbox Drive
Service Interval: After the first 100 hours—Change the
gearbox-drive oil.
Every 500 hours—Change the gearbox-drive oil (or
yearly, whichever comes first).
Note: Change the oil when it is warm, if possible.
1. Park the machine on a level surface and move the
carriage all the way to the rear stop.
75
Figure 96
96).
Advertisement
Table of Contents
