Table of Contents
Advertisement
Drive-Speed Switch
The switch sets the speed at which the machine will travel.
Move the switch up for high speed or down for low speed.
Operator-Presence Switch
Press and hold this button to enable the other controls on the
drive pendant. The machine will stop moving if you release
this button.
Drill Pendant
The drill pendant (also referred to as the life-jacket
pendant) is designed to allow you rudimentary control
over only the drilling features when connected to the front
receptacle, should the operator platform controls become
non-responsive. You can also plug this pendant into the rear
drill-pendant receptacle in the event that the drive pendant
malfunctions to obtain basic movement functions at slow
speed.
Only the drive functions can be operated from the rear
drill-pendant receptacle.
Refer to
Figure 17
for location.
1 2
1. Left switch
2. Center switch
3
g021839
Figure 21
3. Right switch
Left Switch
•
When connected to the drill-pendant receptacle, move
this switch up to move the drill carriage forward or down
to move the drill carriage rearward.
•
When connected to the drive-pendant receptacle, move
this switch up to move the left track forward or down to
move the left track rearward.
Center Switch
Move this switch to the left to enable the pipe loader and
wrench operation; move the switch to the center to turn off
the drilling fluid.
Right Switch
•
When connected to the front drill-pendant receptacle,
move this switch up to rotate the drill spindle clockwise
or down to rotate the drill spindle counterclockwise.
•
When connected to the rear drill-pendant receptacle,
move this switch up to move the right track forward or
down to move the right track rearward.
Stake-Down Levers
1
2
1. Left-stake-raise/lower
lever
2. Left-stake-spin lever
Stake-Raise/Lower Levers
Push down on these levers to lower the stakes into the ground.
Pull up on these levers to raise the stakes out of the ground.
Note: The D
/D
RIVE
be switched to the D
RIVE
Stake-Spin Levers
Push down on these levers to spin the stakes clockwise. Pull
up on these levers to spin the stakes counterclockwise.
Note: The D
/D
RIVE
be switched to the D
RIVE
29
3
4
Figure 22
3. Right-stake-raise/lower
lever
4. Right-stake-spin lever
switch on the operator panel must
RILL
position for this function to work.
switch on the operator panel must
RILL
position for this function to work.
g021835
Advertisement
Table of Contents
