Table of Contents
Advertisement
Controls
Refer to the following sections for the appropriate machine
controls:
•
Operator Platform
•
Monitor
•
Control Panel
•
Left Joystick—Mode I
•
Left Joystick—Mode II
•
Right Joystick—Mode I
•
Right Joystick—Mode II
•
Exit-Side-Lockout System (Standard Range)
•
Exit-Side-Lockout System (Long Range)
•
Rear Control Panel
•
Drill Frame and Stabilizer Controls
•
Drive Pendant
•
Drill Pendant
•
Stake-Down Levers
•
Battery-Disconnect Switch
Operator Platform
The operator platform, located on the right, front corner of
the machine, contains most of the controls you use to operate
the drilling functions of the machine.
1. Operator display
2. Left control panel and
joystick
Figure 8
3. Right joystick
Operator-Controls Covers
The covers protect the operator controls from adverse
weather conditions, such as rain, wind, sunlight, etc. Remove
them before using the machine and replace them before
leaving the machine for the day. Each cover is secured with 2
screws as shown in
Figure
1. Screws
Operator-Platform Latch
The operator platform swings out away from the machine,
making room for you to sit. It has 4 positions: travel (swung
all the way into the machine), full-out, and 2 intermediate
positions. Return the platform to the T
moving the machine.
To release the platform and swing it out or in, press down on
the rear platform latch
1. Rear platform latch
21
9.
Figure 9
2. Covers
position before
RAVEL
(Figure
10).
Figure 10
Advertisement
Table of Contents
