Front Control Panel - Toro 2226 Operator's Manual

Front Control Panel

Figure 29
1. Engine-speed switch
2. Engine-start button
3. Work-lights switch
4. Emergency engine stop
button
5. Exit-side lockout—standby
light (orange)
Engine-Speed Switch
•
Push and hold the top of this switch to increase
the engine speed.
•
Push and hold the bottom of this switch to
decrease the engine speed.
•
Release the switch to maintain the current engine
speed.
Engine-Start Button
Push this button (Figure
key switch on the rear, control panel must be in the O
position. Ensure that both emergency stop switches
are in the raised position.
Work-lights Switch
Push the top of this switch
machine lights on or the bottom of the switch to turn
them off.
6. Exit-side
lockout—drill-enabled
light (green)
7. Exit-side-lockout handheld
battery-status light (red)
8. Exit-side-lockout—reset
switch
9. Ground-strike-reset switch
10. Drill/setup switch
29) to start the engine. The
(Figure 29) to turn the
Emergency Engine Stop Button
Push this button
the engine and all drilling operations. You must pull
this button out before you can start the engine again.
Exit-Side Lockout—Standby Light
This light (Figure
exit-side lockout is turned off, indicating that you may
reset the system.
Exit-Side Lockout—Drill-enabled Light
This light (Figure
exit-side-lockout system has been reset and the
machine is ready to drill.
Exit-Side-Lockout Battery—Status Light
This light (Figure
on the exit-side-lockout transmitter is too low to
transmit. Stop drilling operations and replace the
batteries in the transmitter before continuing.
g218968
Exit-Side Lockout—Reset Switch
Push this switch
operation when the yellow reset light illuminates.
Ground-Strike-Reset Switch
Push this switch
system after a ground strike has occurred and been
fixed; refer to Deploying the Zap-Alert System (page
51).
Drill/Setup Switch
Push the top of this switch
setup controls or the bottom of the switch to enable
drill and pipe-loader functions.
N
29
(Figure 29) to immediately shut off
29) illuminates orange when the
29) illuminates green when the
29) illuminates red when the battery
(Figure 29) to enable drilling
(Figure 29) to reset the Zap-Alert
(Figure 29) to enable the