Left Joystick-Mode I - Toro 2024 Operator's Manual

Left Joystick—Mode I
Note: The joystick controls vary depending on the control
mode you select when powering up the machine. There
are 2 control modes: Mode I and Mode II; refer to the
Control-Select Screen in the Software Guide for information
on setting the control mode.
1
5
6
7
Figure 13
1. Joystick—move left
2. Joystick—move forward
3. Joystick—move rearward
4. Joystick—move right
5. Toggle switch
Trigger
The trigger changes the other joystick controls from pipe
loader controls to wrench operation controls.
•
Press the trigger to enable the wrench controls.
•
Release the trigger to enable the pipe loader controls.
Toggle Switch
•
Left trigger pressed—rock the switch forward to
rotate the upper wrench clockwise to loosen a joint;
rock the switch rearward to rotate the upper wrench
counterclockwise to tighten a joint.
•
Left trigger released—rock the switch forward to rotate
the pipe cam out towards the pipe loader; rock the switch
rearward to rotate the pipe cam towards the drill frame.
2
4
3
8
9
g021833
6. Front button
7. Rear button
8. Lower button
9. Trigger
Front Button
•
Left trigger pressed—press this button to resume the
previously set auto-drill speed. Press and hold this button
to increase the auto-drill speed.
•
Left trigger released—press this button to close the pipe
gripper.
Rear Button
•
Left trigger pressed—press this button to set the auto
drill speed. Press and hold this button to decrease the
auto-drill speed.
•
Left trigger released—press this button to open the pipe
gripper.
Lower Button
In the event of a sensor failure, use this button to override the
pipe cam presets and manually move the cam. Only operate
in this mode if absolutely necessary; you could damage the
pipe cam or pipes if you do not align them correctly. If the
sensor fails, contact your Authorized Toro Dealer for repair.
Joystick—Forward
•
Left trigger pressed—closes the lower wrench.
•
Left trigger released—retracts the pipe gripper toward
the pipe holder.
Joystick—Rearward
•
Left trigger pressed—opens the lower wrench.
•
Left trigger released—extends the pipe gripper toward
the drill frame.
Joystick—Left
•
Left trigger pressed—opens the upper wrench.
•
Left trigger released—lowers the pipe elevator.
Joystick—Right
•
Left trigger pressed—closes the upper wrench.
•
Left trigger released—raises the pipe elevator.
23