Using The Cylinder Lock - Toro 2024 Operator's Manual

2. Pull the hood latch out
Figure 60
1. Hood latch
3. Lift up the handle as shown in
Figure 61
1. Hood handle
(Figure 60).
Figure 61.

Using the Cylinder Lock

WARNING
The thrust frame may lower when it is in the raised
position, causing serious injury or death.
Install the cylinder lock before performing
maintenance that requires the thrust frame to be
raised.
Installing the Cylinder Lock
1. Start the engine.
2. Lower the thrust frame to the fully-lowered position.
3. Stop the engine.
4. Position the cylinder lock over the cylinder rod
62).
5. Secure the cylinder lock with the cotter pin and clevis
pin (Figure 62).
6. Turn the engine to the O
thrust frame until it rests on the cylinder lock.
1. Cotter pin
2. Cylinder lock
3. Lift cylinder rod
Removing and Storing the Cylinder
Lock
1. Start the engine.
2. Lower the thrust frame to the fully lowered position.
3. Stop the engine.
4. Remove the cotter pin and the clevis pin that secure the
cylinder lock (Figure
5. Remove the cylinder lock.
6. Turn the engine to the O
thrust frame.
59
position, and raise the
N
Figure 62
4. Clevis pin
5. Lift cylinder
62).
position, and raise the
N
(Figure