Table of Contents
Advertisement
Setting Up the Pump to Use a Natural Water Source
To set up a pump to use a natural water source, you must
ensure that you use the Y-screen to filter all materials other
than water.
To install the Y-screen perform the following tasks:
1. Remove the pump-inlet cap
1. Pump threads
2. Pump-inlet cap
2. Align the Y-screen with the threads on the pump
(Figure
48).
3. Rotate and tighten the Y-screen onto the pump.
4. Attach the hose to the Y-screen, and begin pumping
from the natural water source.
(Figure
48).
Figure 48
3. Y-screen
Drilling the Bore
Starting the First Pipe
1. Ensure that all bystanders are away from the machine
and that the exit-side lockout is On.
2. Move the drill carriage fully down the drill frame and
spray the spindle threads with thread joint compound,
then return the drill carriage to the upper end of the
frame
(Figure
43).
1. Drill spindle
3. Rotate the pipe gripper to the first row of pipes in
the pipe holder by aligning the row indicator to row
number 1.
4. Lower the pipe elevators to load a pipe into the pipe
gripper.
5. Rotate the pipe gripper with the pipe toward the drill
frame, and extend the pipe until the pipe is centered
over the frame and in front of the spindle on the drill
carriage.
6. Rotate the drill spindle clockwise and move the carriage
slowly forward to insert the spindle into the female end
of the pipe
(Figure
49
Figure 49
2. TJC-applicator nozzle
50).
Advertisement
Table of Contents
