Table of Contents
Advertisement
Figure 35
1. Upper pins
3. Place a block at the front and rear of the trailer and/or
truck tires.
4. Using the drive pendant, set the engine speed to slow,
and the drive speed to slow.
5. Using the drive pendant, carefully drive the machine
forward or rearward up the ramp and into position on
the trailer.
6. Lower the stake-down plate to the deck of the trailer.
7. Turn off the engine.
8. Use appropriately rated chains and binders to secure
the rings on the left and right track frames and the
stake-down plate to the trailer
Figure 36
1. Tie-down points (only right side shown)
9. Measure the distance from the ground to the highest
point on the machine for reference to ensure that you
do not collide with low hanging obstacles.
10. Remove the block from the trailer tires, and stow them
with the machine for use when unloading it.
2. Lower pins
(Figure
36).
11. After driving a few miles, pull over and check to ensure
that all chains are still tight and that the machine has
not moved.
To unload the machine, reverse the above procedure.
44
Advertisement
Table of Contents
