Controls; Operator Platform - Toro 2226 Operator's Manual

Controls

Refer to the following sections for the appropriate
machine controls:
•
Operator Platform (page 27)
•
The Software Guide
•
Front Control Panel (page 29)
•
Joysticks in Setup Mode (page 30)
•
Left Joystick (page 31)
•
Right Joystick (page 32)
•
Exit Side Lockout (page 33)
•
Rear Control Panel (page 33)
•
Travel Pendant (page 33)
•
Battery-Disconnect Switch (page 34)

Operator Platform

The operator platform, located on the right, front
corner of the machine, contains most of the controls
you use to operate the drilling functions of the
machine.
Figure 26
1. Front control panel
2. Left joystick
Operator-Controls Covers
The covers protect the operator controls from adverse
weather conditions, such as rain, wind, sunlight, etc.
Remove them before using the machine and replace
them before leaving the machine for the day.
g218950
3. Right joystick
4. Operator display
Operator-Platform Latch
The operator platform swings out away from the
machine, making room for you to sit. It has 5 positions:
travel (swung all the way into the machine), full-out,
and 3 intermediate positions. Return the platform to
the T position before moving the machine.
RAVEL
To move the platform, push up on the rear platform
latch or push down on the front platform latch
27).
To release the platform and swing it out or in, push up
on the front platform latch
27
Figure 27
(Figure 27).
(Figure
g218956