Note:
To raise or lower the blade, add a shim
(Part No. 3256-24) between the spindle housing
and the bottom of the cutting unit. Continue
to check the alignment of the blades and add
shims until the tips of the blades are within the
required dimension.
Important:
Do not use more than 3 shims at
any 1 hole location. Use decreasing numbers
of shims in adjacent holes if more than 1
shim is added to any 1 hole location.
9.
Adjust the idler pulley and install the belt covers.
Cab Maintenance
Cleaning the Cab
Important:
Use care around the cab seals and
lights
(Figure
130). If you are using a pressure
washer, keep the washer wand at least 0.6 m (2 ft)
away from the machine. Do not use the pressure
washer directly on the cab seals and lights or
under the rear overhang.
1. Seal
2. Light
Cleaning the Cab Air Filters
Service Interval: Every 250 hours
1.
Remove the screws and grates from both the
in-cab and rear cab air filters
Figure
132).
81
Figure 130
3. Keep wand 0.6 m (2 ft)
away.
4. Do not pressure-wash
under the rear overhang.
(Figure 131
g034330
and